Prints stuck at layer 2 with Prusa Slicer

I'm having some issues with progress estimates and the displayed current layer does not go past 2. Prints fine. Running RepRapFirmware 3.1.1 but the issue was also present with 2.05 before upgrading Update: The total layer count on this specific print is

The Prusa I3 MK3S And A Tale Of Two Sensors

3D Printer Review: Kingroon KP3S 3D Printer - Product Design Online

How to Avoid Layer Separation in Your 3D Prints

Prusa Slicer Bridging. How on earth should this work? Instead of bridging the entire top layer, it prints the posts & then tries to bridge (without having a place to attach the

Troubleshooting the Prusa MMU2S - Tim Broddin

Incorrect support speed , seems to stuck at some low speed. · Issue #439 · supermerill/SuperSlicer · GitHub

PrusaSlicer 2.6 alpha5 stuck at 70% · Issue #10034 · prusa3d/PrusaSlicer · GitHub

PrusaSlicer not leaving Horizontal Gaps – PrusaSlicer – Prusa3D Forum

Why does PrusaSlicer decide to print layers slower than other layers? : r/ender3

Insert pause or custom G-code at layer