Rectract Before Outer Wall not working - ZScar issues - UltiMaker

Hi, I'm having some issues with the zscar, I already try most of the possible combinations with Cura settings and I am continuing having problems as we can see in the image below. - I think the main problem that is causing the issue in the image, is the lack of pressure inside the extruder when i

Compensate Wall Overlaps - causing zits - UltiMaker Cura

4.1.0] Ignored options: outer before inner walls and infill

A visual Ultimaker troubleshooting guide - 3DVerkstan Knowledge Base

Outer wall - gap between end and start points? - UltiMaker Cura

printing round things without constant reversals of travel

UMs5 Wall Separation Issue - UltiMaker 3D printers - UltiMaker

Ugly seams, under extrusion? - UltiMaker Cura - UltiMaker

A visual Ultimaker troubleshooting guide - 3DVerkstan Knowledge Base

print quality - Under extrusion when starting outer wall - 3D

Thin gap between outer wall and inner wall, only on small circular

Outer Before Inner Walls - gaps at the beginning wall - UltiMaker

Spiralize Outer Contour IGNORES all retraction · Issue #12498

Rectract Before Outer Wall not working - ZScar issues - UltiMaker