Lightburn GCode Inverts Light and Dark on Photos - Snapmaker 2.0

I have a photo that I have dithered using imag-r.com using Norton tile method. Everything looks great in Lightburn using Threshold but when gcode runs on SM2, it prints as if inverted has been selected which is hasn’t. It also prints this way on the Lightburn dither options with the exception of grayscale at S-Value 254. @brent113…you have a lot of Lightburn experience. Have you seen this before? I started with LB 9.20 and have bumped down to 9.13. I am on SM2 firmware version 1.9.0. I have look

CONFIGURATION – LaserGRBL

Snapmaker Image Inverting - Snapmaker - LightBurn Software Forum

Invert/Negative Image? - LightBurn Software Questions - LightBurn Software Forum

Fiber Laser Test

In SnapMaker the Lightburn red fill lines are laser engraved - LightBurn Software Questions - LightBurn Software Forum

Firmware request: Tool Change Mode with enclosure lights left ON - #22 by MooseJuice - Snapmaker 2.0 - Snapmaker: where creation happens

ATOMSTACK X20 S20 PRO 130W Metal Laser Engraver With Air Assist Laser Engraving Cutting Machine 20W Laser Cut 30mm Wood/Acrylic - AliExpress

Full Lightburn Control Guide - Snapmaker 2.0 - Snapmaker: where creation happens

Snapmaker Image Inverting - Snapmaker - LightBurn Software Forum

Confused by output of Inverted Image - LightBurn Software Questions - LightBurn Software Forum

Snapmaker Image Inverting - Snapmaker - LightBurn Software Forum