Temperature Drops after Print Starts - AO-101 & AO-100 - LulzBot

Hey Guys, So I had to put in new thermistor recently, did some other structural changes (60mm height increase) and wired in a fan which isn’t currently connected. Yet now I am getting this issue with my hotend where once the print start the temperature drops even though it looks like the extruder is still rocking it. I ran PID autotune, stored the values, brought the bed and then the hotend up too 230C using Repetier. Then I dropped in the GCODE. You can see down below the temperature curve. T

Flash printer - AO-101 & AO-100 - LulzBot

3-D Printing for Aeromodeling

Arduino « Midsouth Makers – Memphis Area Makerspace

Extruder Struggling - AO-101 & AO-100 - LulzBot

Cura Settings Decoded – An Ultimaker Cura Tutorial

Temperature Drops after Print Starts - AO-101 & AO-100 - LulzBot

Is this lisitng too good to be true? Am I going to be missing a kidney : r/3Dprinting

LulzBot Mini Review: Compact, Powerful Yet Easy to Use

3D Printing Troubleshooting Guide

E3D Titan Aero toolhead for Lulzbot TAZ

3D Printer Review: LulzBot AO-101 - 3D Printing Industry

Mosaic Palette Users, Hello All, I recently changed out my ender 5 for a cr-10 v2 and I have been trying to get my palette working with it correctly

Temperature Drops after Print Starts - AO-101 & AO-100 - LulzBot