Z Axis Probing Issues - General Discussion - Klipper

Basic Information: Printer Model: Custom CoreXY MCU / Printerboard: rPi 4B, Octopus V1.1 & FLY SHT42 klippy.log (851.2 KB) I have two issues that need to be addressed when trying to implement sensorless homing that will allow SAVE_CONFIG updates from functions like SHAPER_CONFIGURATION. This is a continuation to Problem with SHAPER_CALIBRATE & TMC2209s with Sensorless Homing 1. Updating printer.toolhead.homed_axes after single axis homing: I’m using the following code to implement TMC2

Best posts made by Argo

Neptune 4 Plus - v1.2.2.64 firmware issues : r/elegoo

Klipper module for 7x7 Mesh on a Mk2s (original bed) – General discussion, announcements and releases – Prusa3D Forum

Does anyone do sensor less homing on their Z-axis? : r/BIGTREETECH

Klipper: Sensorless Homing – What Is It & How to Set It Up

Issues with pressure advance since RRF 3.4

Communication timeout during homing probe + Extrude below Min Temp Errors - General Discussion - Klipper

Hot end temp for tap probe - General Discussion - Team FDM

Anybody using a Duet board with a Klipper SBC?